Dating mouth word

Feature #2 (mold seam diameter) is not as strongly diagnostic as the primary indicators as mouth-blown bottles sometimes can have very fine mold seams.Feature #7 describes a couple glass related features that are quite consistent in machine-made bottles, but not diagnostic, i.e., mouth-blown bottles may sometimes have few/no bubbles in the glass and even thickness.The machine is operated much as all pressing machines are..." (National Glass Budget 1910; Lockhart pers. This little bottle has a moderately narrow neck and a distinct valve or ejection mark on the base indicating press-and-blow machine manufacture. The 1908 photo below is from the Lewis Hine collection (Library of Congress) and shows an early, probably O'Neill (Barrett 2011) semi-automatic press-and-blow 4 mold milk bottle (which have relatively wide mouths) machine which came with the following caption: "Machine that blows 4 milk bottles at a time. Blowing air would have been supplied by the hose visible at the top of the set of blow molds to the left, where the final "blow" part of the cycle took place.

This distinctive base scar is easier to illustrate than describe; click on suction scar for a picture of a typical scar which exhibits the diagnostic "feathering" that surely indicates Owens machine production (same image is below left).

There are at least two additional finish related mold seams - one at the top of the finish which encircles either the bore or sometimes the outside of the upper lip portion of the finish (sometimes of these seams are present) and a horizontal seam immediately below the finish which circles the extreme upper neck (called a "neck ring parting line").

Click on the picture to the left to view an illustration which shows both of these seams or click machine-made finish to view an image which shows well the seam below the finish.

There are also no horizontal tooling marks present on the finish and/or upper neck as would be observable on the finish of mouth-blown bottles.2.

The side mold seams on most machine-made bottles tend to be finer (narrower and lower) - though sometimes sharper and/or visually distinct than mouth-blown bottle mold seams although many mouth-blown bottles have very thick and distinct seams due to less precise mold construction or fitting.

Leave a Reply